If you’ve ever hired a professional plumber for something simple, you know how expensive and annoying the experience can be. If you’d like to save a little cash by learning how to solve your own plumbing problems, read on. This article will give you the knowledge you need for your own plumbing repair.
Rigid copper is used for main water lines in many homes. You cannot bend rigid copper, so joints and tees must be soldered on. When soldering, always apply flux (also called soldering paste) to both surfaces. Flux retards oxidation when the copper is heated. Always use lead-free or nearly lead-free solder when sweating a copper joint.
You always want to solder correctly, the biggest mistake most people make when soldering is failing to get the interior of the fitting and the exterior of the pipe clean and shiny. Polish these surfaces with a fine emery clot until bright. When soldering, never heat the pipe, but instead heat the fitting. Doing so allows the solder to be drawn into the fitting by capillary action.
Having your septic tank pumped out on a regular basis will keep it functioning properly. This stop sedimentary particles from accumulating in the tank, and in the worst cases, flooding your home or making the entire system to fail. It will cost some to have the septic tank pumped, but it would cost much more to have it cleaned, repaired or replaced due to sewage back up.
If you have issues with the plumbing making a hammering sound when you turn it off, check your water pressure. Any time your water pressure is above 80 PSI, you will hear extra water noise. This can be easily solved by the installation of a pressure-reducing valve, which can be done by most homeowners.
You need to winter-proof your house. You have to make sure you switch of the master circuit breaker or the shut-off valve before you leave your house. Since one small hole or congested water can quickly freeze and cause pipes to break and expand, you need to drain and open all outdoor and household water lines.
Check your gas water heater periodically to make sure the pilot flame is lit. The correct color for this flame should be blue. The tip of the flame should be yellow. If you find that you are only seeing a yellow flame, you may need to call a professional for safety reasons.
At least once a year remove the faucet aerator and clean the screens. This helps it properly function. The function of a faucet aerator is to allow for an even flow of water and to conserve water. Be sure to clean out the aerator and you’ll notice a these things working.
As you can see, hiring a professional plumber is usually an unnecessary and expensive thing to do, compared to fixing the problem yourself. Next time your plumbing needs repair, try pulling up this article and trying to solve it yourself. You may be surprised how easy it is to do!